OEM Grade Camera Kit with Gentex® 3345 Homelink® Mirror, Fits 2010-2013 Tundra®

2010-2013 Tundra® - Select the desired handle configuration from the box above when ordering.

NOTE: Some 2012 and 2013 trucks are not prewired even though the chassis harness is in place. You need to test each of the pins at the back for continuity in the front overhead console. This can be accomplished by using an ohm meter with a long extension wire and alligator clips. Clip one end of the wire to a pin at the back and carefully poke the opposite end of your tester into each of the overhead console wires to test for continuity. In the event that your Tundra® camera wiring does not run all the way through you will need to order the Tundra® full wire harness kit CSH-TUN-3345.

If you purchase just the camera module you will install our camera module into your camera-ready handle using the included bolts, route the harness through the bottom of tailgate and plug in on the frame rail.  This will only bolt into a factory or aftermarket handle with the OEM camera opening.  You cannot drill a hole and make this system work.

If you purchase in a handle simply replace your existing tailgate handle with this handle containing the integrated backup camera. Two 10mm bolts hold your handle in place, swap the lock, fish the camera wire through the tailgate, plug in to your chassis, and reassemble. The entire camera installation process can take less than 20 minutes. 

Replace your factory mirror with the included Gentex® mirror by removing the upper center console, remove the old mirror, swap with the new mirror, plug into the existing harness, and reassemble! - another 15-20 minutes. 

NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.