10-13 Toyota Tacoma Backup Camera for Factory Radios - Opt. Pop and Lock
NEW! 6 VOLT SYSTEM Integrate a rear camera into your Display Audio system
- Camera module and radio integration harness only (without the Pop and Lock) - choose this option if you want to use your existing tailgate handle
- Camera pre-loaded in a Pop and Lock PL5500 locking tailgate handle (comes with it's own set of keys)
- Camera pre-loaded in a Pop and Lock PL5400 locking tailgate handle (uses your ignition key to train the lock tumbler -- no additional keys needed!)
Premium camera kit with an OEM look- high resolution chip for superior quality in color, clarity, and night vision. This camera will also allow you to see the rear bumper and trailer hitch for easy connections - even at night! This camera kit provides the ultimate package in safety and security! Available with a black Pop & Lock PL5500 or PL5400 locking tailgate handle, this combination looks like a factory camera, but outperforms the factory camera in all categories. This kit comes with all the wiring and connectors to install into your truck. Kit is completely plug and play so no need to run a new wiring harness under your chassis... uses your existing wiring!
This package contains:
- Premium day/night vision camera, mounted in PL5500 or PL5400 locking tailgate handle (optional).
- Toyota rear camera integration tailgate harness
- Toyota Display Audio interface harness
- Detailed Installation instructions
- 3-Year camera warranty!
Additional Information: This camera module will mount in your existing tailgate handle, or if you order the Pop and Lock the tailgate handle assembly and camera replace your existing handle as an exact factory replacement kit. The harness allows for the camera to be connected directly to your Display Audio system so you can view the camera output on your radio when in reverse.
|Waterproof/Dustproof Level||IP 67|
|Night Vision||< .2 Lux|
|Power Supply||6 Volts|
|Camera Resolution||600 TVL|
|Parking Guidelines||Selectable on/off|
|Camera Orientation||Rear Facing|
|Fit Type||Factory OE Fit Replacement|
|Connection||Plug and Play to Factory Dash Display|
|Sensor Type||Super CMOS|
|Viewing Angle||170 Degrees|
|Camera Type||Rear Camera|
|Number of Cameras||1|
|Reason for Shopping||Adding the camera(s)|
|Wiring Type||Factory Plug&Play|
|Camera Mount Location||Factory Tailgate|
|For a monitor it uses:||Your factory display|
|Radio Screen Size||6.1" LCD|
2010-2013 Toyota Tacoma with Display Audio radio.
If you are pre-wired this kit simply plugs in at the frame rail using the tailgate disconnect factory plug. The total install will take 10-15 minutes!
If you are not pre-wired you will run a new harness to the cab, come through an existing grommet in the floor board, then connect the camera harness to the radio using the included radio interface harness. This harness simply plugs right in to the radio without any cutting or splicing and this harness will also supply power and ground to the camera, which makes things really simple. You'll remove your Display Audio Radio and install the radio interface harness as per the instructions. Remove the drivers side A-pillar cover and lower instrument panel cover to gain access to the necessary plugs and cable routing. Connect the included radio harness to the connector inside the A-pillar then route the harness to the back of the radio You will also need to install the included reverse trigger wire into pin 2 of the factory radio bundle to trigger the radio into camera mode when you go to reverse. The total installation time is about 90 minutes or 120 minutes for DIY.