2020 GM Heavy Duty Work Truck, Plug and Play Flush Mount Camera
- Black flush mount camera with our latest super CMOS camera - the latest camera technology!
- Mounting hardware
- OEM conversion harness 5', 10',15' 25' cable lengths available. Select from drop down above.
- 22.5 mm hole saw
- Zip ties
- Installation instructions
- 3 year limited camera warranty
- Super CMOS chip - outstanding color, contrast, and clarity!
- Removable parking guidelines
- 150 degree view
- 600 TV lines of resolution
- .1 lux minimum illumination - Outstanding night vision!
**This is for a Work Truck only- Window sticker and/or VIN will show (WT).
|Waterproof/Dustproof Level||IP 67|
|Night Vision||< .2 Lux|
|Power Supply||12 Volts|
|System Manufacturer||EVI Systems|
|Camera Resolution||600 TVL|
|Parking Guidelines||Selectable on/off|
|Camera Orientation||Rear Facing|
|Fit Type||Universal fit|
|Sensor Type||Super CMOS|
|Viewing Angle||150 Degrees|
|Camera Type||Rear Camera, Utility Bed Camera Systems|
|Vehicle Category||Truck, Fleet Vehicle (i.e. cargo van)|
|Number of Cameras||1|
|Reason for Shopping||Relocating factory camera|
|Wiring Type||Factory Plug&Play|
|Camera Mount Location||Camper/Utility Bed, Universal Mount|
|For a monitor it uses||Your factory display|
|Radio Screen Size||Factory LCD|
|Model||Sierra HD,Silverado HD|
2020 GMC Sierra and Chevrolet Silverado 2500,3500,4500,5500 series "Work Truck" with factory installed backup camera wiring and "IOR" RPO code. Contact your GM dealer with your VIN number to determine that your VIN has the "WT" specification and the "IOR" RPO code.
Also confirm that you have the 30 pin connector for the camera wiring at the back of the truck.
**This is for a Work Truck only- Window sticker and/or VIN will indicate (WT).
**EVI Systems has certified this camera system to comply with FMVSS 111 regulations as set forth by the National Highway Traffic Safety Administration (NHTSA). Testing has been performed jointly in-house and by a certified laboratory to meet or exceed the minimum requirements set forth by TP-111-V-01. FMVSS 111 field of view requirements and any other vehicle related certification is ultimately the responsibility of the vehicle up-fitter to ensure compliance.
Camera requires a 22.5 mm hole on a flat surface for flush mounting. It will require a flat section approximately 1" x 1" for mounting. Drill the hole and connect the camera harness to the OEM conversion harness. Run the cable to your factory backup camera 30 pin connection under the truck and plug it in.