Plug-Play Surface Mount Cab and Chassis Camera Kit, Fits 2019 Ranger
This universal camera is surface mounted so it will require a flat section approximately 1" x 1" for mounting. Drill a small hole and run the cable through to your factory backup camera connection.
Kit includes the following:
- Chrome or black plated rear facing surface mount camera with our latest super CMOS camera - the latest camera technology!
- Mounting hardware
- OEM conversion harness
- 5', 10', 15', 25' cable lengths available. Select from drop down above.
- Zip ties
- Installation instructions
- 3 year limited camera warranty
- Super CMOS chip - outstanding color, contrast, and clarity!
- Removable parking guidelines
- 170 degree view
- 600 TV lines of resolution
- .1 lux minimum illumination - Outstanding night vision!
|Waterproof/Dustproof Level||IP 67|
|Night Vision||.1 Lux|
|Power Supply||12 Volts|
|System Manufacturer||EVI Systems|
|Camera Resolution||600 TVL|
|Parking Guidelines||Selectable on/off|
|Camera Orientation||Rear Facing|
|Fit Type||Universal fit|
|Sensor Type||Super CMOS|
|Viewing Angle||170 Degrees|
|Camera Type||Rear Camera, Utility Bed Camera Systems|
|Vehicle Category||Truck, Fleet Vehicle (i.e. cargo van)|
|Number of Cameras||1|
|Reason for Shopping||Relocating factory camera|
|Wiring Type||Factory Plug&Play|
|Camera Mount Location||Camper/Utility Bed, Universal Mount|
|For a monitor it uses||Your factory display|
|Radio Screen Size||Factory LCD|
2019 Ford® Ranger Cab and Chassis trucks that have been pre-wired for a camera from the factory and have a 4.2" or 8" display from the factory that is programmed to recognize a back up camera.
This kit relies on the factory camera chassis harness to operate.
Not compatible if your truck has the 360 view system.
See our other Ranger truck options if your truck came from the factory with a bed and you are removing the bed to add service body, utility bed, dump truck, flat bed, and any other application where you do not have a tailgate. This kit will only work on the trucks that came from the factory without a bed. Please verify the connector shown in the photos against the connector on your truck before ordering. If you are still not sure please call us for assistance.
**EVI Systems has certified this camera system to comply with FMVSS 111 regulations as set forth by the National Highway Traffic Safety Administration (NHTSA). Testing has been performed jointly in-house and by a certified laboratory to meet or exceed the minimum requirements set forth by TP-111-V-01. FMVSS 111 field of view requirements and any other vehicle related certification is ultimately the responsibility of the vehicle up-fitter to ensure compliance.
Camera is drill-in style for surface mounting. It will require a flat section approximately 1" x 1" for mounting. Drill a small hole and connect the camera harness to the OEM conversion harness. Run the cable to your factory backup camera connection under the truck and plug it in.