Integrated Electronic Trailer Brake Controller, Fits 2011-2014 Ford® F-150
Easily add a trailer brake controller! OE fit!
Don't go aftermarket, easily add a 100% factory Ford® plug & play electronic trailer brake controller to your truck in less than 25 minutes! This integrated brake controller allows the driver to automatically or manually activate the electronic brakes on properly equipped trailers for greater stopping power on downhill grades. Drivers can customize the amount of brake force applied to the trailer brakes depending on the load, and independent of the truck's brakes.
No dealer programming required, simply use the included OBD programmer after installation to activate the feature!
VEHICLE COMPATIBILITY
2011-2014 Ford® F-150
See our other options for different model year F150's and Super Duty trucks.
WHAT'S INCLUDED?
- 100% factory OEM Ford® Trailer Brake Controller
- OBD Programmer - Programs the truck within 30 seconds to activate the feature.
THINGS TO KNOW
- In rare cases some trucks may not be pre-wired at the module connector for 12v power & ground. In this instance you may order the fuse jumper kit JL3Z-14A411-C to remedy the issue.
- You can only add a factory trailer brake controller to F150's with a factory installed tow package featuring a receiver hitch and 2 trailer connection plugs (7 pin and 4 pin). If your truck doesn't have the Ford® factory installed receiver and only has the 4 pin trailer plug and bumper hitch, this will not work for you.
SKU | F-TBC-1114 |
---|---|
Connection | Factory Connector |
Warranty | 1 Year |
Wiring Type | Factory Plug&Play |
Make | Ford |
Model | F-150 |
Year | 2011,2012,2013,2014 |
Make Filter | Ford |
Model Filter | F-150 |
Year Filter | 2011, 2012, 2013, 2014 |
2011-2014 Ford® F-150
See our other options for different model year F150's and Super Duty trucks.
*You can only add a factory trailer brake controller to F150's with a factory installed tow package featuring a receiver hitch and 2 trailer connection plugs (7 pin and 4 pin). If your truck doesn't have the Ford® factory installed receiver and only has the 4 pin trailer plug and bumper hitch, this will not work for you.
Partial dash piece removal to access factory mount for trailer brake controller. Controller easily bolts into place. Locate factory wire harness under the dash and plug-in controller. Reassemble dash.
Plug programmer into OBD port located under the steering wheel. Trailer Brake Controller feature is activated in less than a minute!
**In rare cases some trucks may not be pre-wired at the module connector for 12v power & ground. In this instance you may order the fuse jumper kit JL3Z-14A411-C directly from a FORD dealership to remedy the issue.
Click here for a link to the install video for trucks with a 4.2 inch factory display.
Click here for a link to the install video for trucks with an 8 inch factory display.
NOTE: Your question may be included on the product page but your name will not be displayed for privacy reasons.
10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount10% OFF Discount for Military and Public Service Workers
Thank You Veterans and Civil Servants!
Get the Discount